DESCRIPTION

Screen Tensiometer

1.The tension meter has been calibrated to zero before leaving the factory, and users should not adjust it by themselves.

2.Reading method: The reading of the second rotation of the tensiometer pointer is accurate

(and the mesh next to the tension meter should be lightly slid).

PRODUCT INFORMATION       

Commonly used mesh maximum bearing tension

The data in the table was tested based on Swiss medium and thick yarn, specifically tension is relatedto

the quality of mesh stretching machine, with good quality mesh stretching machine, the mesh yarn

can reach the highest tension and not broken.

However, if the mesh yarn is beyond the maximum withstand tension,

its easily broken. Please kindly refer to below data:

Tensiometer is used to measure the tension of the stretched mesh, and is an indispensable tension measurer in the stretched net process.

Selecting a high-precision tensioner is the key to plate making and overprinting.

The tensiometer is easy to operate and easy to read. The error is small and the accuracy is high.

The tensiometer is an instrument that measures the amount of mutual traction between the inside

of the wire mesh and the fixed wire mesh contact when the wire mesh is under tension.

The unit for measuring tension is expressed in Newtons / cm.

Tension can also be expressed in relative values.

The centimeter tensiometer is a kind of relative tension, which is calculated by the value of the depth

of the tensiometer to sink the wire mesh (mm). The tension value can be obtained directly from the

indicator panel or indirectly from the control panel. get.

Tensiometer is an important testing instrument to check the quality of screen printing plate.

In order to ensure the tension required by the plate making, the tension meter should be used during or after the stretching.

Reading display mode: the first reading of the tensiometer reading pointer is incorrect,

the second reading of the tensiometer rotation is normal, and the net yarn

beside the tensiometer must be shaken

Feature:

1.This product is a portable, compact, mechanical tension measuring device for accurate and

consistent measurement of all screen printing fabrics in Newtons per centimeter (N/cm).

2.It consists of a shock-resistant measuring base with a precision mechanical dial indicator.

it works on the principle of force deflection; the unique design of the meters 3-point measuring

base permits accurate measurement on the screen (polyester, nylon or wire), independent of the

screen frame or stretching device.

3.Substantial improvement in tension measuring methods as compared to touch control, gauging

by percentage of fabric elongation, and air pressure values.

4.Accurate tension measurements will improve registration and reduce rejects, resulting in

increased productivity.

5. Reproducible and uniform tension measurement, screen after screen.

Tensiometer Accessories

Note: The tension of the mesh is N/cm, which means how much tension the mesh has in the width per cm

(usually expressed in N-Newton or Kg-kg, 1 kg = 9.8 Newton).

So Newton shows that the tension meter has The actual number of tensions.

Measurement Methods And Steps

counterclockwise to allow the zeroing dial to rotate. Rotate the zero plate to zero and confirm.

MeasuringFlip mesh and place it horizontally (PCB contact side up) place the tensiometer at the four corners and center of the screen,

check the tension value at each point, and record the minimum value. Check whether the screen tension test value is within

the allowable range, if the measured value does not meet the standard, please feedback to the engineer for processing.

After the measurement, put the tensiometer back into the box in time, and then put it back on the knife holder.